We haven’t installed the stair railing due to the need for adjustments in the posts (they don’t make an angled post as far as I could tell.)
The Cable Bullet intermediate post is a sleek, surface-mount, structural pass-through post, designed to support both your cables and top rail, with the smallest visual footprint possible. These posts can be used with Signature Series tensioning posts, or as infill for custom wood railing. Use with cable spacer bars to maximize the view from your deck, patio, or stairway.
The intermediate post features a stainless steel universal top that may be fastened to a wood or aluminum top rail and is designed to pivot for straight or sloping runs. The post body includes pre-drilled cable pass-through holes every 3 inches on center, optimally sized for use with 5/32" diameter cable (max.). 36-inch posts are designed for 11 cables, 42-inch posts for 13 runs each. The elongated, tapered hole design offers the necessary support fo level runs, while still allowing the cable to pass through without kinking along sloped spans.
Each post includes one universal top, base plate, and base plate cover. Top rail fasteners and mounting screws not included.
The structure supporting your posts must be able to handle the transferred loads of the railing system (150-200 lbs of tension per cable). It is the installer’s responsibility to make certain that the structure your posts are fastened to is capable of supporting the applied loads.
Handrails are also a structural component of cable railing and must be able to resist both the compression load of the tensioned cable and perpendicular guardrail loads.
For more information, please read our terms of service.
When designing your railing layout, follow these guidelines.
Once your post locations have been identified, mark and drill pilot holes for the post-mounting lag screws. Angle each post according to your cable runs before securing them. Before tightening the lag screws, plumb each post using the leveling set screws at the base. Once your posts are secured, set the base cover plate.
Use the ¼” Spanner Nut Bit to loosen the two threaded pins on either side of the stainless steel post top. Once your top rail is set, mark and drill pilot holes for each top mount. Secure the top rail, then tighten the threaded pins.
Note: To ease the installation of your top rail you may detach the u-shaped top-mounting bracket from the post top completely by removing both threaded pins. Detaching and installing the top-mounting bracket is especially helpful when installing top rail on sloped runs, or where spacing is tight.
Your posts are now ready for cable infill. Complete this process using the Cable Bullet Metal Post Installation Instructions.
|Material:||Aluminum Post Body, T304 Stainless Steel Top|
|Coating:||Powdercoat, TCI 9030-90922 SD "Super Durable" FLAT BLACK|
|Overall Height:||36", 42"|
|Post Top:||1-11/16" W x 1-1/4" D|
|Post Body:||3/8" W x 2" D|
|Post Base:||2" W x 3-1/2" D x 7/8" H|